Shure SLX Wireless

shure slx wireless systems:

Wireless system offers easy set-up and high audio quality for virtually any application. Features include Automatic Frequency Selection, Automatic Transmitter Set-Up, Predictive Diversity technology, and removable antennas with rack hardware.

Frequency Band Selection

Most countries closely regulate the radio frequencies used in the transmission of wireless Infor mation. These regulations state which devices can use which frequencies, and help to limit the amount of RF (radio frequency) interference in all wireless communications. To be flexible enough to operate worldwide, SLX receivers are available in a number of models, each with a unique frequency range. Each frequency range, or band, spans up to 24 MHz of the

wireless broadcast spectrum.

To facilitate system setup and protect against RF interference, each system comes with multiple predefined frequency groups and channels.

When using a single SLX system, the operating frequency will generally not have to be changed. In an installation with multiple receiver/transmitter systems, each system must operate on a sepa rate channel. The group and channel system provides an optimum frequency spread when using multiple systems.

Within a single frequency band, up to 12 individual transmitter/receiver systems may be used in a single installation. In regions where additional frequency bands are available, it is possible to operate up to 20 systems simultaneously. Check with your local Shure retailer for information on which bands are available in your area

shure slx wireless systems instructions:

Single System Setup
Follow these steps when using a single SLX system : Automatic Frequency Selection Scans for an available channel and sets the receiver to that channel . Automatic Transmitter Setup
1. Turn On the transmitter.
2. Open the transmitter battery compartment to display the infrared ( IR ) port
3. With the IR port exposed to the receiver , press sync .
4. Hold the sync button until the red light stops flashing on both receiver and transmitter .
5. When the receiver ready light glows , the system is ready for use .
6. Close the transmitter battery compartment .